Insulated liners
Insulation is wrapped around the liner or poured into the space around it where the system or chimney calls for it.
A sweep in Somerdale can reline an unlined or damaged flue so smoke and gases vent safely from a fireplace, stove, insert, furnace or water heater. One call to (856) 344-1158 reaches a nearby sweep who installs liners.
A chimney liner is the channel inside the chimney that carries smoke and combustion gases up and out. Without one, heat and acidic condensation attack the masonry, and gaps can let heat or carbon monoxide escape into the home. In older houses, it is common to find an unlined chimney or a clay tile liner that has failed.
There are a few reasons a chimney gets a new liner. Clay tiles crack after chimney fires, shift as the house settles and lose mortar at the joints, while some chimneys never had tiles to begin with. Installing an insert, stove or high efficiency furnace often means the old flue is the wrong size.
Before relining, the chimney should get a thorough inspection, usually a Level 2 inspection with a camera run up the flue. It helps decide between repair and relining, and between flexible and rigid stainless. Seeing the inside of the flue makes the decision much easier.
Depending on what the sweep finds, chimney liner installation in Somerdale, NJ can go hand in hand with chimney liner repair and chimney inspection.
Looking for Somerdale chimney liner installation? Call (856) 344-1158 and describe the problem to a chimney sweep who works in Somerdale.
Call nowRelining a chimney is a careful job that starts well before the liner goes in.
A camera is run through the flue to check the existing tiles, offsets and obstructions. This confirms what kind of liner the chimney needs.
The liner diameter is matched to the appliance outlet or the fireplace opening, following the manufacturer guidance. The route and any offsets are noted.
The flue is swept and any loose tile or obstruction is cleared so the liner can pass. The path from top to bottom has to be clear.
The stainless liner is lowered from the roof down to the appliance, often wrapped in an insulation blanket. Insulation keeps the flue warm for better draft and helps meet clearance rules.
The bottom connects to the stove, insert or appliance, and the top is sealed with a top plate and cap. The connections keep gases from leaking into the old flue.
A draft test confirms the new liner is working. This is also a good time to test your CO alarms.
Insulation is wrapped around the liner or poured into the space around it where the system or chimney calls for it.
A poured liner fills gaps and creates a new flue and can add strength to older masonry.
A rigid liner is heavier and smoother inside for a strong, smooth flue.
Flex liners snake through chimneys with bends and offsets and are common for inserts, stoves and gas appliances.
Liners sized for gas and oil appliances to keep combustion gases moving out of the house.
Most relining jobs use stainless steel, which handles high heat and corrosive flue gases well. It comes in flexible coils for chimneys with bends and rigid sections for straight flues. Liners are sold as tested systems, with grades suited to wood, gas or oil.
Insulation around the liner helps flue gases rise and keeps the outside of the chimney cooler. At the top, a sealing plate and cap keep rain and animals out. Many Somerdale chimneys get a stainless liner when an old fireplace is converted to an insert.
Relining means putting a new liner into a chimney that has an old, damaged or missing one. The most common triggers are chimney fires, settling cracks, missing mortar and appliance changes. Relining is usually far less disruptive than rebuilding the chimney.
Before relining, it helps to know which appliances share the chimney. A furnace replaced with a high efficiency model that vents through the wall can leave the water heater alone in an oversized flue, which leads to poor draft and condensation. A smaller liner brings the draft back where it should be.
In Somerdale, older homes often have unlined chimneys or clay tiles that have cracked with age. From Somerdale out to places nearby like Magnolia, Stratford, Echelon and Lawnside, wood stoves and inserts are common, and each one needs a properly sized liner, which is why relining is one of the most common chimney upgrades in the area.
Need chimney liner installation around Somerdale? Call (856) 344-1158 for a Somerdale chimney sweep who serves the towns around it too.
Cold winters keep fireplaces, wood stoves and oil burners working for half the year or more. The hardest thing on brick here is not the cold itself but the constant swing above and below freezing: rain and melting snow soak into the crown and joints, then freeze and push them apart, which is how cracks, loose bricks and leaks start. Wind driven rain from coastal storms finds any gap in flashing, too. That is why chimney cleaning in Somerdale is usually booked in the fall, before the first cold night.
A chimney problem fixed early rarely spreads to the masonry, the liner or the house.
Local sweeps see the same chimney types and weather wear across Somerdale and nearby towns.
Ask your questions before you agree to anything.
More questions? Call (856) 344-1158
Fixing gaps, cracks and missing mortar inside the flue liner with resurfacing, joint repair or partial replacement.
Learn moreA level 1, 2 or 3 review of the full chimney system to catch cracks, blockages and leaks before they turn into hazards.
Learn moreFitting a fireplace insert so an open fireplace becomes a real heat source, so more heat stays in the room instead of going up the flue.
Learn moreWood stove installation into an existing chimney or a new insulated chimney, following the stove manual and local code.
Learn moreLooking for something else?
See all chimney servicesCall (856) 344-1158 to talk to a chimney sweep serving Somerdale, NJ.
Free to call. No forms to fill out.